Wavetronix SmartSensor 105 (SS-105) - User Guide Instrukcja Użytkownika Pobierz pdf (Strona 61)

60 CHAPTER 6  LANE SETUP

4 Click the Restart button at the lower right.

5 Conrm the conguration restart by clicking Yes in the box that appears (see Figure

6.1). SmartSensor Manager will now automatically begin detecting and conguring

lanes, and the screen will show a visual depiction of the lanes and vehicle detections

in real time.

Figure 6.1 – Conﬁrming Automatic Lane Conﬁguration

6 After the lanes have been detected and congured correctly, save the conguration

by clicking the Finished button. e time required for conguration depends on the

volume of trac present in the lanes, but is typically only a few minutes.

Note

After clicking the Finished button, wait for one minute before turning o the sensor.

During this time the sensor is completing adjustments of the conﬁguration thresh-

olds. Typically this is not a problem because veriﬁcation may be needed in Trac

View after clicking Finished. The veriﬁcation process will normally be longer than

one minute.

Edit Range Blinders

Range blinders are an optional setting available in Automatic mode. Using range blinders

will narrow the search area of the automatic lane conguration process (range blinders

have no eect in Manual Conguration mode), allowing you to congure faster and avoid

conguring undesired lanes such as frontage roads. Use the steps below to successfully edit

the range blinders:

1 Click the Range Blinders button. Red bars (range blinders) will appear at the top and

bottom of the roadway display and any previously displayed roadways will be cleared.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 98 99

Brak uwag

Wavetronix SmartSensor 105 (SS-105) - User Guide Instrukcja Użytkownika Strona 61