Wavetronix SmartSensor 105 (SS-105) - User Guide Instrukcja Użytkownika Pobierz pdf (Strona 53)

52 CHAPTER 5  SENSOR SETTINGS

ments. Metric units are entered in decimeters so that the metric and English units can

be converted more accurately.

 RF Channel – is allows you to assign specic RF channels to sensors that are in-

stalled in close proximity to each other to prevent the sensors from interfering with

each other.

Communication Tab

e Communication tab allow you to change the following settings (see Figure 5.3):

Figure 5.3 – Communications Tab

 Baud Rates – Allows you to set the baud rate for the each of the sensor’s four connec-

tion ports. To change the baud rate, simply click on the drop-down menu and select

the desired rate. Besides the standard RS-232 and RS-485 ports, there are also two

other expansion ports. ese expansion ports are currently not available for use.

 Response Delays (milliseconds) – Allows you to change the number of milliseconds

that the sensor will delay before responding. is is useful if you ever attach the sen-

sor to communication equipment that cannot handle the speed with which the sensor

responds to message requests. You can change the response delay for each of the four

connection ports separately by entering the desired number of milliseconds. If you are

not able to determine the amount of delay required by consulting the communication

equipment’s documentation, you will need to determine this number by trial and error.

Note

If you increase the response delay, you should also increase the additional response

wait time that SmartSensor Manager uses when communicating to the sensor.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 98 99

Brak uwag

Wavetronix SmartSensor 105 (SS-105) - User Guide Instrukcja Użytkownika Strona 53