Wavetronix SmartSensor 105 (SS-105) - User Guide Instrukcja Użytkownika Pobierz pdf (Strona 39)

38 CHAPTER 4  COMMUNICATION

Modem Connection

Clicking the Modem (Phone #) radio button on the New Connection page and then click-

ing OK will allow you to connect to the SmartSensor using a modem. e Modem Con-

nection page has a text box in which you can enter the phone number for the sensor’s

modem (see Figure 4.4).

Figure 4.4 – Modem Connection

e phone book icon to the right of the text eld allows you to browse for numbers pre-

viously saved in the SmartSensor Manager address book (for more information, see the

Address Book section later in this chapter). If you’d prefer to dial manually, click the Dial

Manually check box beneath the text eld, then click on Dial. At this point you will need

to pick up the telephone receiver and manually dial the phone number.

Note

When this window is ﬁrst opened, the modem connection phone number you used

most recently will automatically appear in the text ﬁeld.

Once the number is entered, click Dial to make a connection. Click Cancel to stop the

action and return to the New Connection page.

e message bar at the bottom of the page, identied by the icon, shows the modem

settings being used. If the default settings are used, the message bar will display the fol-

lowing:

ID - Simple; Synchronize - Yes; Wait - 0

Advanced Modem Settings

e following settings are part of the modem connection’s advanced functions and can be

found by clicking the Advanced button (see Figure 4.5):

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 98 99

Brak uwag

Wavetronix SmartSensor 105 (SS-105) - User Guide Instrukcja Użytkownika Strona 39