Wavetronix SmartSensor Matrix (SS-225) - Quick-reference Guid Instrukcja Użytkownika Pobierz pdf (Strona 2)

Lane conﬁguration option 1: automatic conﬁguration

ese settings are found under Sensor Settings on the SSMM main menu.

General Tab

˽ Serial Number – e sensor’s serial number; cannot be edited.

˽ Sensor ID – Used to uniquely identify all sensors on a multi-drop bus; by de-

fault is the last seven digits of the sensor’s serial number and cannot be edited.

˽ Description/Location/Approach – For identication/information. Descrip-

tion and Location are limited to 64 characters, Approach to 32 characters.

˽ RF Channel – Setting sensors to dierent channels prevents radars from

interfering with each other.

˽ Sensor Height – In feet; aects the display of data in SSMM.

˽ Units – Choose between Standard or Metric.

Ports Tab

˽ Response Delay – Allows you to congure how long the sensor will wait before responding to a mes-

sage received. e green arrow points to the port over which you are currently connected.

˽ Data Push – Lets you set over which port data is being pushed.

˽ Source – Choose between Antenna and Diagnostic.

Use the following steps to auto-congure the SmartSensor Matrix:

1 Select Sensor Setup from the SSMM main menu. e Sensor Setup screen

will appear. If the Lanes & Stop Bars screen is not already open, click on tab 1

to open it.

2 Move the sensor to the desired orientation by clicking the button (bot-

tom of screen).

3 Click the button to clear the edit area.

4 Start automatic lane conguration by clicking the

button and selecting

Restart Auto Lane Cfg from the window. Allow the intersection to cycle at

least twice before proceeding (this could take several minutes).

Note. To see your automatically congured lanes, you must have your display set

to Automatic Conguration overlay (click the Auto Cfg tab at the top right of the

screen).

5 Once the automatically congured lanes have appeared, capture the lanes and stop bars. To capture, click

once on a lane to highlight it, and then again to bring up the Capture Lane window. Select Capture Lane or

Capture All. Any stop bars in the captured lanes will be captured as well.

6 Make manual adjustments, if necessary (see Part 5).

7 Save your changes to the sensor by clicking the button.

Enter the sensor settings

1 2 3 4

Brak uwag

Wavetronix SmartSensor Matrix (SS-225) - Quick-reference Guid Instrukcja Użytkownika Strona 2