Wavetronix SmartSensor HD (101-0415) - Quick-reference Guide Instrukcja Użytkownika Pobierz pdf (Strona 4)

WX-500-0170

8,665,113; and Cdn. Pat. Nos. 2,461,411; 2,434,756; 2,512,689; and Euro. Pat. Nos. 1435036; 1438702; 1611458. Other US and international patents pending. Wavetronix, SmartSensor, Click,

Command and all associated logos are trademarks of Wavetronix LLC. All other product or brand names as they appear are trademarks or registered trademarks of their respective hold-

ers. Product speciﬁcations are subject to change without notice. This material is provided for informational purposes only; Wavetronix assumes no liability related to its use.

Complete sensor alignment

To conrm correct sensor installation and ne-tune sensor alignment, install the SmartSensor Manager HD

(SSMHD) soware using the steps below:

1 Download the setup program from the Wavetronix website, www.wavetronix.com. Go to the Support

tab, select SmartSensor from the drop-down menu, then select SmartSensor HD from the list. Click

the link for SmartSensor Manager HD under the Soware heading.

2 Double-click on the le and follow the steps included in the install wizard.

Install the SmartSensor Manager HD (SSMHD) software

Make a connection

SSMHD allows for three connection types: serial, Internet, and virtual (for

testing and demonstration). You’ll most commonly make a serial connection.

To do this:

1 Make a physical or wireless connection to the sensor. is will likely

involve making a wired or wireless connection to a Click device that has

a communication connection with the sensor—for instance, to a device

that is on the same T-bus as the Click 200 surge protector the sensor is

connected to.

2 Launch SSMHD and click the serial button on the Connect section

of the main menu.

3 Change any necessary settings, such as port or speed.

4 Click Connect.

1 Select Lanes from the main menu, then Conguration.

2 Click on the magnifying glass icon and then click Show Alignment. Adjust

the sensor according to the arrow and the colors shown on the detected

vehicles. Green means the sensor is positioned for optimal performance;

yellow or red means the sensor is NOT correctly aligned with the roadway.

3 Once the sensor is properly aligned, tighten the strap screws the rest of the

way.

For the sensor alignment tool to function properly, trac must be owing

freely. Aer each adjustment of the sensor, several vehicles must pass before the

alignment tool’s output is valid. Also, if the sensor is not already aligned close to

perpendicular to trac, this tool will display a question mark, indicating that the

sensor is too far out of alignment for the tool to function properly.

1 2 3 4

Komentarze do niniejszej Instrukcji

Brak uwag

Wavetronix SmartSensor HD (101-0415) - Quick-reference Guide Instrukcja Użytkownika Strona 4

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Czujniki Wavetronix SmartSensor HD (101-0415) - Quick-reference Guide