Wavetronix SMARTSENSOR 105 Przewodnik Instalacji Pobierz pdf (Strona 6)

SmartSensor 105 User Guide – Wavetronix LLC 9/20/07 - -

Installing the SmartSensor

Installing the SmartSensor involves seven simple steps:

1. Attaching the mounting bracket to the pole;

Applying silicon dielectric compound;

Attaching the SmartSensor to the mounting bracket;

Aligning the SmartSensor;

Connecting SmartSensor cable to the SmartSensor;

Connecting SmartSensor to Power and Communication Devices;

Configuring the SmartSensor using SmartSensor Manager™.

Figure 1 – Detection range of a properly mounted SmartSensor

1. Attaching the Mounting Bracket to the Pole

1. Measure the offset from the first detection lane to the pole as demonstrated in

Figure 1 above.

2. Look up the recommended mounting height from Table 1 on the following page.

NOTE: Depending on the site and type of traffic the sensor may tend to over- or

undercount. If the sensor is over-counting, reduce the height of the sensor by 3

feet and reconfigure the sensor. If the sensor is under-counting, increase the

height of the sensor by 3 feet and reconfigure. Normally, reducing the height of

the sensor improves performance.

3. Strap the mounting bracket to the pole at the specified height using stainless steel

straps.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Brak uwag

Wavetronix SMARTSENSOR 105 Przewodnik Instalacji Strona 6